I've read a lot on this forum about people not knowing how to shoot Opana's or Opana ER's, so here it is people. A perfect way to shoot both pills while still keeping the opioid levels high. I have shot both, so this comes from my own person experience NOT from something I've read elsewhere. Also I have only ever shot 40mg Opana's and 40mg Opana ER's, so I do not have any experience shooting the lower mg Opana's, but I would assume it works the same way.
First I must warn you of the risk of overdosing because shooting Opana's can be extremely dangerous due to the high dosage of opioid in the pill and if you have a very low tolerance I do not recommend doing it. I, myself, have a very high tolerance and have been injecting opioids for over 2yrs and almost overdosed on Opana's once. So use very little when injecting Opana's. I only use 1/3 to 1/6 of a pill and get very high. Be careful.
Second I DO NOT recommend shooting the Opana ER's because these contain silicified microcrystalline cellulose, in other words silica which is very poisonous and harmful to your veins and lungs. Regular Opana's DO NOT contain silica and are way less harmful to inject. Every time I have injected Opana ER's about 45 minutes to 1 1/2 hours later I get extreme uncontrollable shakes. It's almost like a seizure except you're conscious for and I would know because I have had 3 Gran Mal Seizures in the past 4 years. The shakes are caused from the silica which when shot compress your lungs and both your blood pressure and oxygen levels are severely decreased. If you still wish to shoot Opana ER's despite my warning when you do get the shakes take big, deep, steady breaths. I have found that this helps a great deal. Right after the shakes go away, which they last about 30 minutes, you get extremely high so it's almost worth the risk, ALMOST.
Now what everyone has been waiting for, the actual shooting of Opana's and Opana ER's.
You can only use 1/3 of the pill at a time because anymore creates too much gel and you'll never get anything out of it, but 1/3 is all you'll need trust me. First remove to coating by cutting or scraping it off. If you're worried about losing any of the pill just put the coating in a napkin or tissue and parachute it or just eat it. After removing the coating crush up 1/3 into a fine powder and place into the spoon. Then add 250cc's of water, I know it's a lot, but if you don't it will all be gel. The goal here is to offset the gel with water, so there's too much water for it all to become gel. After mixing the water with the powder, heat it. Heat it nice and good until it all boils. If done correctly there will still be water in the spoon which contains the opioid. Add cotton to filter out the remaining gel. The water will be a little jelly, but you'll have no problem getting it in the needle. I usually get about 90cc's to 120cc's of Opana, so either use a 100cc needle or a couple 50cc needles. Now you'll wanna shoot it within 10 minutes because the gel will cool and get thick again. Next, as we all know, find a vein, shoot up and enjoy the high. It is nice and lasts a long time, but the rush isn't great. You DO get a rush, but it's not the greatest rush I've ever felt. Again, BE CAREFUL, it is extremely powerful.
Once more I DO NOT suggest shooting the Opana ER's. It is extremely dangerous and possibly fatal. This method works flawlessly, trust me I just shoot up about an hour ago and I'm nice and high. I hope this helps people out. I have also found that this method works with generic Oxycontin's and other pills that gel up. The goal is to off set the gel with water. Please, as always, be careful while using drugs. I would feel horrible if anyone overdosed because of this post, but I figured it'd be best to tell people the safest way to shoot Opana's instead of them doing something stupid and dangerous. Enjoy.




Bookmarks